Any vids of doing a Zeon install in an already mounted AEV bumper?
Warn Zeon 10s install
Collapse
X
-
Warn Zeon 10s install
I don't have any video, but I took a few pics when I installed my 9.5cti in my already installed AEV tubeless front. Basically, plan on a removal and reinstall of the bumper. I didn't have to take the frame brackets off, but everything else had to come off to put the winch plate and winch on, then I could reinstall the bumper.
Last edited by jwilson2598; 11-30-2014, 08:15 PM.Jeff
2013 Sahara
AEV 2.5 XT lift, front/rear bumpers, hood, argent Pintlers, 315/70/17 Duratracs -
I don't have any video, but I took a few pics when I installed my 9.5cti in my already installed AEV tubeless front. Basically, plan on a removal and reinstall of the bumper. I didn't have to take the frame brackets off, but everything else had to come off to put the winch plate and winch on, then I could reinstall the bumper.
Comment
-
Other than the plastic bumper filler, no trimming or cutting.Jeff
2013 Sahara
AEV 2.5 XT lift, front/rear bumpers, hood, argent Pintlers, 315/70/17 DuratracsComment
-
You have to completely remove the factory vacuum pump bracket from the frame. The plastic trim piece also has to be trimmed different when using a Zeon. Other than that it's the same as installing the 9.5 CTI.Comment
-
Warn
Well I added an M.O.R.E. bracket (for the ARB Compressor) but I used it to hold my Warn Platinum control head that I relocated under the hood. Perfect fit, steady platform for it.
I'll clean up my wiring when it's a little warmer, but I think I am finally out of room under the hood!Comment
-
Comment
-
Is the remote clutch wiring (the 4 flat plug) rubbing on your grill? Im haven't installed my new bumper and winch (awaiting a little body work from a fender bender) and I'm worried now that that wiring (which isn't on the normal zeon obviously) will eventually fail if it is constantly rubbing.2014 JKUR - AEV 3.5" - 37" KO2
2015 Ram Power Wagon - 37" KO2Comment
-
Did you have to do any major mods for this winch to fit?2014 JKUComment
-
No nothing. It fit right in the bumper. It is right up against the grill, but no mods to get it in there.
Sent from my iPhone using Tapatalk2015 AEV JK350 Rubicon Billet unlimited 4.5 37'sComment
Comment